JRC JMR-5410-6X - Section 3 Common Basic Operations; Powering on and Starting; Starting each Mode

3-1 Section 3 Common Basic Operations
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
1
Section 3 Common Basic Operations
3.1 Powering On and Starting
Turn on the power supply according to the following procedure.
1 Press the Power button on the operation unit.
Start-up screen is displayed.
After the start-up screen is displayed, the Mode Selection screen is displayed after a brief
interval.
3.2 Starting Each Mode
When this equipment starts up, a Mode Selection screen is displayed on the screen.
On the Mode Selection screen, you can select and start the desired mode from the operation modes
available for this equipment.
When the button of the mode to be executed is clicked on, the screen of the mode is displayed.
Memo
When this equipment is started for the first time, if no operation is performed within 10 seconds
after the Mode Selection screen is displayed, the mode screen that has been set up at the time of
shipment will appear.
Power button