JRC JMR-5410-6X - Setting up the Operation Mode; Basic Operation of the [Settings] Dialogue

13-1 Section 13 Setting up the Operation Mode
１
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
Section 13 Setting up the Operation
Mode
13.1 Basic Operation of the [Settings]
Dialogue
You can set up the operation mode in the [Settings] dialogue.
Classification pane display targets
The table below provides the classification panes that are displayed and the related sections.
Classification pane Related section
Signal Process
13.2 Setting Radar Signal Processing
Obs. Scene Preset
13.3 Presetting Each Observation Scene
Obs. Scene Common
13.4 Observation Scene Common Settings
Trails
13.5 Setting Other Ship’s Radar Trails
Trails Masking
13.6 Setting Radar Trail Mask
TXRX
13.7 Setting Radar Antennas
Association
13.8 Setting Associations
Ship's Dynamic Trait
13.9 Setting Own Ship's Dynamic Trait
Preset of Same Fleet
13.10 Setting Consort Ship Preset
TT Test
13.11 Setting Operation Tests
Filter
13.12 Setting AIS Filters
Target Track
13.13 Setting the Target Track Function to ON/OFF
NAVTEX
13.14 Setting NAVTEX
Event Mark
13.15 Setting an Event Mark
Geodetic
13.16 Setting Datum Conversion
General
13.17 Setting Navigation Equipment
GPS
13.18 Setting GPS
DGPS
13.19 Setting DGPS
SBAS
13.20 Setting SBAS
Cursor, EBL/VRM
13.21 Setting Cursor, EBL/VRM
Colour and Brightness
13.22 Setting Colours and Brightness
Sounds
13.23 Setting Sounds
Key Assignment
13.24 Setting Key Assignment
Preferences
13.25 Setting Preferences Information
Screen Capture
13.26 Setting Screen Capture