Section 14 Adjusting and Setting up Equipment (for Services)
14-4
14.2.2 Adjusting radar antenna
Adjust the radar antenna by using the [TXRX] dialogue.
[Operation procedure]
Open the radar antenna adjustment dialogue by performing the following menu operations.
[Menu] button → Service → Adjustment → TXRX
14.2.2.1 Adjusting an radar antenna height
1
Measure the height from the sea surface to the radar antenna.
2 In the [Antenna Height] combo box, select a setting value corresponding to the
antenna height that was measured in Step 1.
• Under 5 m
• 5-10 m
• 10-20 m
• 20 m Over
14.2.2.2 Setting a tuning bar peak value
Set the scale when the tuning indication bar touches the peak value.
• This function is disabled under radar slave mode.
• Not displayed when a solid-state radar antenna or a NKE-2255 radar antenna is connected.
1 Set the range to 48 NM or more.
2 Click on the [Tune Indicator] (tuning bar adjustment) input box.
A numeric value input keyboard is displayed.
3 Input a setting value in the input box so that the tuning bar oscillates within the range
from 80% to 90% of the maximum amplitude position (0 to 127).
For the method of using the numeric value input keyboard, refer to "3.19.2 Name and function
of each section of the keyboard".
To Next Page
Loading...
