JRC JMR-5410-6X - Setting up the Display of Newpec

11-13 Section 11 Setting up Screen View
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
付録
11.1.10 Setting up the display of newpec
Set drawing of newpec.
Display of newpec can be set only when newpec is selected in [Chart View].
[Operation procedure]
Open the newpec drawing setting screen by performing the following menu operations.
[Menu] button → View → newpec
The following table shows the setting descriptions.
[Contour] tab
Setting Item Description of Setting Setting Value
Page1
Safety Contour
Set Display/Hide and depth of the safety contour.
Off / 2 m / 5 m / 10 m
Contour Display Display/hide the contour. When this item is selected,
the following items are displayed as Enabled,
enabling the setting.
Shown: Selected
Hidden: Clear
Shallow Contour
Set a minimum depth of the contour to be displayed.
0 to Deep Contour
Deep Contour Set a maximum depth of the contour to be displayed. Shallow Contour to
9999
Contour Interval Set a drawing interval of the contour to be displayed. 1 m / 5 m / 10 m / 100
m
Line Type Set a line type of the contour to be displayed. Solid line / dotted line /
dashed line /
chain line /
two-dot chain line /
chain line2 /
two-dot chain line2
Colour Mode Set a colour mode of the contour.
Simple Colour: Draws a contour with the specified
colour.
Standard: Colours according to the depth with the
newpec standard colour.
Simple Colour /
Standard
Colour Set a colour of the contour to be displayed. This item
is displayed only when [Simple Colour] is selected in
Colour Mode.
White / Grey / Amber /
Magenta / Blue /
Cyan / Green /
Yellow / Orange /
Dark Red