Section 13 Setting up the Operation Mode 13-8
13.4 Observation Scene Common
Settings
Set observation scenes to be assigned to any of the short range, middle range, and long range.
[Operation procedure]
Open the observation scene common setting screen by performing the following menu operations.
[Menu] button → Settings → Obs. Scene Common
Setting Item Description of Setting Setting Value
Short (Short range)
Select a range of observation scene “AUTO(S)”.
A range shorter than MID (middle range) and
Long (long range) can be set.
NM/sm:
0.125 to 48.000
Km:
0.15 to 64.000
*The maximum value
is less than the range
that is set in MID.
MID (Middle range)
Select a range of observation scene “AUTO(M)”.
A range longer than Short (short range) and
shorter than Long (long range) can be set.
NM/sm:
0.25 to 96.000
Km:
0.3 to 128.000
*The minimum value is
greater than the range
that is set in Short.
Long (Long range) Display the range of observation scene
“AUTO(L)”. The value that was set in the middle
range is displayed.
-
Obs. Scene - Short Select an observation scene to be set in
observation scene “AUTO(S)”.
Standard / Coast /
Open-Sea / Fishnet /
Storm / Calm / Rain /
Bird / Long / Buoy /
User1 / User2
Obs. Scene - MID Select an observation scene to be set in
observation scene “AUTO(M)”.
Same as above
Obs. Scene - Long Select an observation scene to be set in
observation scene “AUTO(L)”.
Same as above
Show Obs. Scene Select an observation scene to display on the
screen.
Checking the checkbox of the Obs. Scene to be
used.
[Standard] is constantly set to On and cannot
change.
[AUTO] is set to Off, setting of [AUTO change
Obs. Scene] is disabled.
To Next Page
Loading...
