Section 13 Setting up the Operation Mode 13-28
13.20 Setting SBAS
Set a SBAS receiver.
[Operation procedure]
Open the SBAS receiver setting screen by performing the following menu operations.
[Menu] button → Settings → SBAS
The following table shows the setting items.
Setting Item Description of Setting Setting Value
Search SBAS
Set whether differential information from the SBAS
receiver is received from a beacon or a satellite.
Beacon / SBAS / AUTO
Ranging
Set whether the SBAS satellite is used as a
positioning satellite.
To enable: Select
To disable: Clear
Type 0 Information
Set whether the information of prohibited SBAS is
used.
To enable: Select
To disable: Clear
SBAS Select Mode Set a selection mode of the SBAS satellite number
to be used.
AUTO / Manual
SBAS No. Set a SBAS satellite number to be used.
This item can be set only when Manual is selected
in SBAS selection mode.
120 to 138
Send Data Sends the setting contents to the SBAS receiver.
During the transmission, “Sending ...” is
displayed as the status. When the transmission
is successful, “Completed” is displayed. When
the transmission failed, “Not Completed” is
displayed.
-
To Next Page
Loading...
