JRC JMR-5410-6X - Presetting each Observation Scene

13-3 Section 13 Setting up the Operation Mode
１
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
13.3 Presetting Each Observation Scene
Adjust the preset of the observation scene according to the oceanographic condition,
with the thorough understanding of the features of the radar signal processing
setting. The optimum radar performance may not be able to be demonstrated due to
the contents of the changed setting or the oceanographic condition at that time.
There are 12 types of observation scenes; you can preset each observation scene.
The items that can be preset are displayed in the editing pane by being divided into six setup
dialogues.
[Operation procedure]
Open the observation scene preset screen by performing the following menu operations.
[Menu] button → Settings → Obs. Scene Preset
The following table shows the items that are displayed for each dialogue.
Memo
Some items may not be displayed depending on the installation setting.
Common
Setting Item Description of Setting Setting Value
Obs. Scene Set up the observation scene. Standard / Coast /
Open-Sea / Fishnet /
Storm / Calm / Rain /
Bird / Long / Buoy /
User1 / User2
Page 1
Setting Item Description of Setting Setting Value
IR
(Interference
Rejection)
Set up the IR (Interference Rejection) function. IR Off / IR Low /
IR Middle / IR High
Target Enhance Set up the Target Enhance function. ENH Off / ENH Level1 /
ENH Level2 /
ENH Level3
Echo Process Set up the Echo Process function.
If the ship's heading cannot be acquired, [PROC
Off] is set.
PROC Off
3Scan CORREL
4Scan CORREL
5Scan CORREL
Remain
Peak Hold
Sea
(sea clutter
adjustment)
You can switch between MAN and AUTO.
MAN: Manually removes sea clutters.
AUTO: Automatically removes sea clutters.
MAN / AUTO