JRC jue-87 - Main Menu Screen Overview

3-4
3.4 Main Menu Screen
The JUE-87 operation adopts a multi-level menu structure with window-menus and hierarchical -
submenus. Refer to clause 3.4.3 and 3.4.4 for confirming the composition of each menu. All the time,
screen displays the newest information by pop-up window.
The menu can be chosen by moving the cursor with the right-, left-, up-, and down- arrow keys and
the targeted item is chosen by pressing
Enter key.
On the pop-up window, a new window opens whenever information occurs, and the windows are
displayed with overlapped when two or more information occurs. Maximum of 10 sheets can be displayed
in piles. Buzzer sounds when pop-up window displays maximum of sheets, so press F10 key to close the
window.
Fig.3.4 Main Manu Screen
The Main menu screen is the starting screen to select the main function and is divided into the following
areas:
(1) MES status area (Upper two lines): Gives the MES status, current date, time, and MES position
(as set under DOS or Setup command).
(2) Main menu area: Gives a list of function you use routinely.
(3) Instruction area (Lower two lines): Gives instruction at the state where you were.
NOTE
Screen saver function is build into IME/DTE.
When you use this function, backlight of IME/DTE is automatically turned off if no key is pressed on
keyboard over a given length of time(depends on the setting). Press any key to turn on backlight of
IME/DTE.
read-Out Edit call-Log Distress Ncs/les-info receive-Mode egC
Position: N 35 41' E 139 34' Course: 011deg Speed: 00.0kn at 02:41(UTC)
Ready Rec(AORW): Good-15 Msg print USB 28 Jan,10 10:28(UTC)
Inm-
Move the cursor to the item you want with ←,→ keys then press <Enter>, or
hold down the <Alt> key and press any capital character
Transmit ：To transmit messages
read-Out ：To read out received message
Edit ：To edit a message or to manipulate files
call-Log ：To display the call-history.
Distress ：To edit a distress alert.
Ncs/les-info ：To display or register NCS/LES information
receive-Mode ：To select receive mode, INMARSAT-C or EGC receive only.
egC ：To select EGC service type.
Hold down the Shift key and press F1 to display HELP-information
°
°
MES status area
(Header area)
Main area
Instruntion area
(Footer area)
C
Transmit
RcvMode:EGC Only