Juniper PTX10001-36MR - Page 20

QSFP28 Network Ports
The PTX10001-36MR has 12 quad small-form factor pluggable (QSFP28) sockets that are congured as
100GbE ports by default.
The QSFP28 network ports support:
• QSFP28 transceivers
• QSFP+ transceivers
• Acve opcal cables (AOC)
• Direct aach copper (DAC) cables
• Direct aach copper break out (DACBO) cables
• QSA adapters
Table 3 on page 11 describes the maximum number of ports for each interface type supported by the
QSFP28 ports.
Table 3: QSFP28 Ports: Maximum Supported Ports at Each Interface Speed
Interface Type Maximum Supported Ports
NOTE: To achieve maximum ports, break out cables might be required.
100GbE 12
40GbE 6
25GbE 24
10GbE 24
NOTE: Port speeds are congured using the set interfaces interface-name speed speed command.
You congure ports to operate at a parcular speed by using the appropriate speed opon. If you
congure a port to operate at a certain speed, and you want to return the port to the default
conguraon, delete the speed statement from the conguraon at the [interfaces
interface-name ]
11