Juniper PTX10001-36MR - Page 31

Figure 9 on page 22 shows the locaon of the fan modules on the device. Figure 10 on page 22
shows an example of the fan module.
Figure 9: PTX10001-36MR Back Panel
1—
Fan modules (6)
2—
Power supplies (2)
Figure 10 on page 22 shows the fan module for the PTX10001-36MR.
Figure 10: PTX10001-36MR Fan Module
You remove and replace a fan module from the back end of the chassis. During replacement, the device
connues to operate for four minutes if one fan module is removed. If two fans are removed, the chassis
will shut down immediately.
NOTE: All fan modules must be installed for normal operaon of the device.
Table 9 on page 23 lists the fan module product SKU.
22