Juniper SRX4600

WARNING: Do not look directly into a fiber-optic transceiver or into the ends
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected
to a transceiver emit laser light that can damage your eyes.
SEE ALSO
Removing an SFP+ Transceiver | 117
Replacing a QSFP28 Transceiver on an SRX4600 Services Gateway
IN THIS SECTION
Removing a QSFP28 Transceiver | 119
Installing a QSFP28 Transceiver | 121
28-Gbps quad small form-factor pluggable (QSFP28) transceivers are hot-removable and hot-insertable
field-replaceable units (FRUs): You can remove and replace them without powering off the device or
disrupting device functions.
Removing a QSFP28 Transceiver
The transceivers for Juniper Networks devices are hot-removable and hot-insertable field-replaceable
units (FRUs). You can remove and replace them without powering off the device or disrupting the device
functions.
NOTE: After you insert a transceiver or after you change the media-type configuration, wait for
6 seconds for the interface to display operational commands.
119