Juniper SRX4600

Packing an SRX4600 Services Gateway or Component for Shipping
IN THIS SECTION
Packing the SRX4600 Services Gateway for Shipment | 145
Packing the SRX4600 Services Gateway Components for Shipment | 146
Before you pack an SRX4600 Services Gateway or component:
•
Ensure that you have taken the necessary precautions to prevent electrostatic discharge (ESD) damage.
•
Retrieve the original shipping carton and packing materials. Contact your JTAC representative if you do
not have these materials, to learn about approved packing materials. See “Contacting Customer Support”
on page 139.
Ensure that you have the following parts and tools available:
•
ESD grounding strap
•
Antistatic bag, one for each component
•
Phillips (+) screwdriver, number 1
Packing the SRX4600 Services Gateway for Shipment
To pack the services gateway for shipment:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to the
ESD point on the chassis or to an outside ESD point if the device is disconnected from earth ground.
.
2. On the console or other management device connected to the services gateway, enter CLI operational
mode and issue the following command to shut down the services gateway software:
user@host> request system power-off
Wait until a message appears on the console confirming that the operating system has halted.
3. Shut down power to the services gateway.
4. Disconnect power from the services gateway.
145