Juniper SRX4600

SRX4600 Services Gateway Installation Overview
To install and connect an SRX4600 Services Gateway:
1. Follow instructions in “Unpacking the SRX4600 Services Gateway” on page 66.
2. Mount the services gateway by following instructions appropriate for your site:
•
Mounting an SRX4600 Services Gateway on Four Posts of a Rack or Cabinet on page 67
3. Connect the grounding cable as described in “Connecting Earth Ground to an SRX4600 Services
Gateway” on page 74.
4. Follow instructions for connecting power as appropriate for your site. See:
•
Connecting AC Power to an SRX4600 Services Gateway on page 75
•
Connecting DC Power to an SRX4600 Services Gateway on page 77
5. Perform initial configuration by following the instructions in “Configuring the SRX4600 Services
Gateway” on page 80.
RELATED DOCUMENTATION
SRX4600 Site Guidelines and Requirements | 46
SRX4600 Rack and Cabinet Requirements | 50
Unpacking the SRX4600
IN THIS SECTION
Unpacking the SRX4600 Services Gateway | 66
Verifying Parts Received with the SRX4600 Services Gateway | 66
65