[edit]
admin@# set system host-name host-name
10. Configure the IP address and prefix length for the management interface on the device:
[edit]
admin@# set interfaces fxp0 unit 0 family inet address address/prefix-length
11. Configure the default route:
[edit]
admin@# set routing-options static route 0.0.0.0/0 next-hop gateway
12. Check the configuration for validity:
[edit]
admin@# commit check
13. Commit the configuration to activate it on the device:
[edit]
admin@# commit
14. When you have finished configuring the device, exit configuration mode:
[edit]
admin@# exit
RELATED DOCUMENTATION
Connecting a Device to a Management Console Using an RJ-45 Connector | 71
Connecting an SRX4600 Services Gateway to a Management Console by Using the Mini-USB Type-B Console
Port
82
To Next Page
Loading...
