Model 2701 User’s Manual Getting Started 1-5
Model 7709 — This module is configured as a 6 × 8 matrix (six rows, eight columns). The
matrix consists of 48 crosspoint channels and two backplane isolation channels. For
system channel operation, row 1 (8 channels) is connected to DMM Input. For 4-wire
measurements, rows 1 and 2 (4 system channels) are connected to the DMM.
Model 7710 — This differential multiplexer provides 20 channels of 2-pole input or
10 channels of 4-pole input. The internal cold junction allows direct-connection of
thermocouples for temperature measurements. This module provides high-speed
switching and uses long-life relays.
Model 7711 — The Model 7711 is a 50Ω, 2GHz, single-pole dual 1 × 4 RF Multiplexer
module (eight channels, no measurement capability). This 1 × 4 multiplexer is a cascading
tree design — one of the channels of each is always connected to a common out. It can be
used to connect one instrument to multiple devices or multiple instruments to a single
device.
Model 7712 — The Model 7712 is a 50Ω, 3.5GHz, single-pole dual 1 × 4 RF Multiplexer
module (eight channels, no measurement capability). This 1 × 4 multiplexer is a cascading
tree design — one of the channels of each is always connected to a common out. It can be
used to connect one instrument to multiple devices or multiple instruments to a single
device.
Cables and connector kits for switching modules
Model 7788 DB-50 connector kit — Contains two male DB-50 solder cup connectors
with strain relief connector shells. These connectors mate to the female connectors of the
Models 7703 and 7705 switching modules.
Model 7789 50/25-pin solder cup connector kit — Contains one male DB-50 and one
male DB-25 solder cup connectors. These connectors mate to the female connectors on the
Models 7701 and 7709 switching modules.
Model 7790 ribbon cable adapter kit — Contains one female DB-50, one male DB-50,
and one male DB-25 IDC ribbon cable connectors. These connectors are used with the
Models 7701, 7707, and 7709 switching modules.
Model 7051-X — BNC cable (male to male). 7051-2 is 2 ft long, 7051-5 is 5 ft long, and
7051-10 is 10 ft long. These cable are used with the Model 7711 switching module.
Model 7712-SMA-1 — SMA cable (male to male), 1.0m (3.3 ft) long. This cable is used
with the Models 7711 and 7712 switching modules.
Model 7712-SMA-N — Female SMA to male N-type adapter. This adapter is used with
the Models 7711 and 7712 switching modules.
S46-SMA-X — SMA cable (male to male). S46-SMA-1 is one foot long and
S46-SMA-0.5 is one-half foot long. This cable is used with the Models 7711 and 7712
switching modules.
To Next Page
Loading...
Need help?
General
