Acquisition Control 13
Keysight InfiniiVision 1200 X-Series and EDUX1052A/G Oscilloscopes User's Guide 139
The higher the number of averages, the slower the displayed waveform responds
to waveform changes. You must compromise between how quickly the waveform
responds to changes and how much you want to reduce the displayed noise on
the signal.
To use the Averaging mode:
1 Press the [Acquire] key, then press the Acq Mode softkey until the Averaging
mode is selected.
2 Press the #Avgs softkey and turn the Entry knob to set the number of averages
that best eliminates the noise from the displayed waveform. The number of
acquisitions being averaged is displayed in the # Avgs softkey.
Figure 26 Random noise on the displayed waveform
To Next Page
Loading...
