Keysight DSOX1202A - Page 30

30 Keysight InfiniiVision 1200 X-Series and EDUX1052A/G Oscilloscopes User's Guide
1 Getting Started
9. Measure
controls
The measure controls consist of:
•[Analyze] key — Press this key to access analysis features like:
• Trigger level setting.
• Measurement threshold setting.
• Video trigger automatic set up and display.
• Display a bus made up of the analog channel inputs where channel 1 is the least significant bit
and channel 4 is the most significant bit. See also Chapter 4, “Analog Bus Display,” starting
on page 55.
• Enable serial bus decodes. See also Chapter 8, “Serial Bus Decode/Trigger,” starting on page
81.
• Reference waveforms (see Chapter 7, “Reference Waveforms,” starting on page 77).
• Mask testing (see Chapter 16, “Mask Testing,” starting on page 179).
• Digital voltmeter (see Chapter 17, “Digital Voltmeter,” starting on page 193).
• Frequency response analysis on models with a built-in waveform generator (see Chapter 18,
“Frequency Response Analysis,” starting on page 197).
•[Meas] key — Press this key to access a set of predefined measurements. See Chapter 15,
“Measurements,” starting on page 155.
•[Cursors] key — Press this key to open a menu that lets you select the cursors mode and source.
• Cursors knob — Push this knob select cursors from a popup menu. Then, after the popup menu
closes (either by timeout or by pushing the knob again), rotate the knob to adjust the selected
cursor position.
10. Tools keys The Tools keys consist of:
•[Save/Recall] key — Press this key to save oscilloscope setups, screen images, waveform data, or
mask files or to recall setups, mask files or reference waveforms. See Chapter 20, “Save/Recall
(Setups, Screens, Data),” starting on page 215.
• [Utility] key — Press this key to access the Utility menu, which lets you configure the
oscilloscope's I/O settings, use the file explorer, set preferences, access the service menu, and
choose other options. See Chapter 22, “Utility Settings,” starting on page 231.
• [Display] key — Press this key to access the menu where you can enable persistence, adjust the
display grid (graticule) intensity, label waveforms, add an annotation, and clear the display (see
Chapter 9, “Display Settings,” starting on page 83).
• [Quick Action] key — Press this key to perform the selected quick action: measure all snapshot,
print, save, recall, freeze display. and more. See "Configuring the [Quick Action] Key" on
page 246.
•[Save to USB] key — Press this key to perform a quick save to a USB storage device.