7.12.7 Sine Encoder with SSI (X1)
Wiring of sine-cosine encoder with SSI interface as a linear feedback system
(primary, ð p.76).
The thermal control in the motor is connected via the encoder cable to X1 and evaluated
there. All signals are connected using our pre-assembled encoder connection cable. If
cable lengths of more than 50m are planned, please consult our customer service.
Frequency limit (sin, cos): 350 kHz
Type FBTYPE EXTPOS GEARMODE
SinCos SSI 5V linear 26 - -
Switch on supply voltage for the encoder at X1: set ENCVON to 1
S701x2-S724x2 Instructions Manual 83
Kollmorgen 07/2014 Electrical installation
S700
SubD 15
To Next Page
Loading...
