Kyocera KM-4035

Maintenance
Description
item No.
2FD/2FF/2FG-3.0
1-4-66
U902 Checking/clearing finisher punch count
Description
Sets the punch limit and displays and clears the punch-hole scrap count when the optional 3000-sheet finisher
is attached.
Purpose
Sets the punch limit to notify the user of the time to collect punch-hole scrap. Also, used to manually clear the
punch-hole scrap count if a message requiring collection of punch-hole scrap is shown on the touch panel after
collection. If punch-hole scrap is collected with the copier power turned off, the punch-hole scrap count is not
cleared and consequently this problem occurs.
Start
1. Press the start key. The screen for selecting in item is displayed.
2. Select the item. The selecting an item is displayed in reverse.
Display Description Setting range Initial setting
PUNCH LIMIT Punch limit 0 to 999000 75000
(maximum number of punching times)
PUNCH COUNT Punch-hole scrap count 0 to 999999 0
(current number of punching times)
Setting the punch limit
1. Change the setting using the numeric keys.
2. Press the start key. The value is set.
Clearing
1. Press the reset key.
2. Press the start key. The count is cleared, and the screen for selecting a maintenance item No. is displayed.
Completion
To exit this maintenance item without changing the current setting, press the stop/clear key. The screen for
selecting a maintenance item No. is displayed.
U903 Checking/clearing the paper jam counts
Description
Displays or clears the jam counts by jam locations.
Purpose
To check the paper jam status. Also to clear the jam counts after replacing consumable parts.
Implementation
Press the start key. The screen for selecting an item is displayed.
Display Description
COUNT Displays/clears the jam counts
TOTAL COUNT Displays the total jam counts
Method: Displays/clears the jam counts
1. Select COUNT in the screen for selecting an item. The count for jam detection by type is displayed.
2. Change the screen using the ∗ or # keys.
3. Select the counts for all jam codes and press the reset key.
4. Press the start key. The count is cleared.
Method: Displays the total jam counts
1. Select TOTAL COUNT in the screen for selecting an item. The total number of jam counts by type is
displayed.
2. Use the ∗ or # keys to switch the display.
The total number of jam count cannot be cleared.
To return to the screen for selecting an item, press the stop clear key.
Completion
Press the stop/clear key at the screen for selecting an item. The screen for selecting a maintenance item No. is
displayed.