2FD/2FF/2FG
1-3-11
1-3-4 Installing the drawer heater (option)
Drawer heater installation requires the following parts:
• Drawer heater (P/N 34860030): for 120 V specifications
• Drawer heater (P/N 33960020): for 220 - 240 V specifications
• Band (P/N M2107120)
Procedure
1. Remove thirteen screws and then the rear
cover.
2. Pull the upper and lower drawers out.
3. Fit the drawer heater to the bottom of the
machine and bind the wire of the drawer
heater with the band.
4. Put the wire of the drawer heater out of the
machine through the aperture of the rear
frame.
5. Remove the four screws and the two
connectors and then remove the wires from
the clamp.
Remove the power source unit from the rear
side of the machine.
Figure 1-3-15
Figure 1-3-16
Drawer heater
Aperture
Band
Connectors
Clamp
Power source unit
Figure 1-3-14
Rear cover
To Next Page
Loading...
