Kyocera KM-4035

2FD/2FF/2FG
1-5-40
Causes Check procedures/corrective measures
1. Foreign matter in the developing unit.
2. Dirty shading plate.
(5) A white line appears
longitudinally.
Causes
1. Foreign matter in the developing unit.
2. Dirty shading plate.
(3) Image is too
light.
(4) Background is visible.
Causes
1. Insufficient toner.
2. Deteriorated toner.
3. The transfer voltage is not output properly.
4. Dirty main charger wire.
Causes Check procedures/corrective measures
1. Insufficient toner.
2. Deteriorated toner.
3. The transfer voltage is not output properly.
4. Dirty main charger.
Causes
1. Deteriorated toner.
2. Dirty main charger.
Causes Check procedures/corrective measures
1. Deteriorated toner. Perform the drum refresh operation.
2. Dirty main charger wire. Clean the wire or, if it is extremely dirty, replace it.
If the display shows the message requesting toner replenishment,
replace the cartridge.
Perform the drum refresh operation.
Clean or check the transfer roller.
Clean the main charger or, if it is extremely dirty, replace it.
Check if the magnetic brush is formed uniformly. Replace the
developing unit if any foreign matter.
Clean the shading plate.