Kyocera KM-4035

2FD/2FF/2FG
1-3-70
If excessive downward curl (case [c] in illustration):
(1) Open the document finisher’s front cover.
(2) Move the lower lever one step to the left.
Note:The lever is initially set to position “1”,
and can be adjusted to five positions (“1” to
“5”).
(3) Run paper through the machine.
(4) Check the downward curl on the ejected
paper.
(5) Repeat steps 2 to 4 until there is no curl.
(6) Close the finisher’s front cover.
If excessive upward curl (case [d] in illustration):
(1) Loosen the four screws and remove the
finisher’s upper cover.
(2) Move the upper lever one step to the right.
Note:The lever is initially set to position “1”,
and can be adjusted to five positions (“1” to
“5”).
(3) Run paper through the machine.
(4) Check the upward curl on the ejected paper.
(5) Repeat steps 2 to 4 until there is no curl.
(6) Reattach the finisher’s upper, and tighten the
four screws.
1
23
4
5
Lower lever
Front cover
Upper cover
Screws
Screws
1
2
3
4
5
Upper lever
Screws
Screws
Upper cover
Figure 1-3-171
Figure 1-3-172
Figure 1-3-173