2FD/2FF/2FG
1-3-24
10. Connect J1 on the IPC PCB to YC15 on the
main PCB.
11. Insert the board supports into the three round
holes of the main PCB and secure the IPC
PCB.
12. Refit the shield cover and rear cover.
YC15
YC4
J1
J2
Main PCB
IPC PCB
Round
hole
Round
holes
Board supports
Board support
Figure 1-3-48
13. Align the rail retainer with the groove of the
guide rail and attach the rail retainer to the
guide rail. Make sure that the plate spring of
the rail retainer fits into the groove and the
edge of the guide rail fits between the pulleys
on the reverse side of the rail retainer.
Rail retainer
Plate spring
Guide rail
Figure 1-3-49
To Next Page
Loading...
