2KJ/2KH
1-3-63
U926
Rewriting FAX program
Description
Downloads the fax program and fax fonts when installing an optional fax kit.
Purpose
To run when upgrading the fax program and fax fonts.
Setting
1. Press the power key on the operation panel, and after verifying the power indicator has gone off, switch
off the main power switch. And then unplug the power cable from the wall outlet.
2. Remove the screw and remove the slot cover.
3. Insert Compact Flash in a notch hole of the machine.
4. Connect the power plug. While pressing the copier key, turn the main power switch on.
Press and hold on the Copier key until the message "Please wait." disappears.
5. Enter the maintenance item.
6. Press the start key.
Downloading of the fax program starts and the result shown below is displayed.
If the operation was successful:
EXECUTE 0100
CHECK SUM ****
CODE 0000
If the operation failed:
EXECUTE 0100
CHECK SUM ****
CODE XXXX
Where XXX is the error code indicating the reason for the failure.
7. Then, downloading of the fax fonts starts and the result shown below is displayed.
If the operation was successful:
EXECUTE 0100
CHECK SUM ****
CODE 0000
If the operation failed:
EXECUTE 0100
CHECK SUM ****
CODE XXXX
Where XXX is the error code indicating the reason for the failure.
See Error Codes for Operation U917 and U926 on P.1-3-61.
8. Press the power key on the operation panel, and after verifying the power indicator has gone off, switch
off the main power switch. And then unplug the power cable from the wall outlet.
9. Remove the Compact Flash from the machine.
10. Refit the slot cover.
Maintenance
item No.
Description
To Next Page
Loading...
