2KJ/2KH
1-3-45
U249
Checking the paper ejection to optional devices
Description
Eject paper to the optional ejection device. When the job separator or the built-in finisher is connected, this
operation cannot be run.
Purpose
To check that paper is ejected properly to the optional ejection device.
Method
1. While pressing the feedshift switch by your hand, press the start key.
Paper transfer operation starts.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
U250
Setting the maintenance cycle
Description
Displays and changes the maintenance cycle.
Purpose
To check and change the maintenance cycle.
Method
1. Press the start key. The currently set maintenance cycle is displayed.
Setting
1. Change the setting using the numeric keys.
2. Press the start key. The value is set.
Clearing
1. Press the reset key.
2. Press the start key. The count is cleared.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
U251
Checking/clearing the maintenance count
Description
Displays, clears and changes the maintenance count.
Purpose
To check the maintenance count. Also to clear the count during maintenance service.
Method
1. Press the start key. The maintenance count is displayed.
Setting
1. Select [COUNT] using the cursor up/down keys.
2. Change the count using the numeric key.
3. Press the start key. The count is set.
Clearing
1. Select [CLEAR] using the cursor up/down keys.
2. Press the start key. The count is cleared.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Maintenance
item No.
Description
Description Setting range Initial setting
Maintenance cycle 0 to 9999999 150000
To Next Page
Loading...
