Kyocera TASKalfa 181

2KJ/2KH
1-3-13
U034
Adjustment: Center line adjustment
1. Select the item to be adjusted using the cursor up/down keys.
2. Press the interrupt key.
3. Press the start key to output a test pattern.
4. Change the setting value using the cursor left/right keys.
For output example 1, decrease the value.
For output example 2, increase the value.
Figure 1-3-2
5. Press the start key. The value is set.
Caution
Check the copy image after the adjustment. If the image is still incorrect, perform the following adjustments in
maintenance mode.
Maintenance
item No.
Description
Display Description Setting
range
Initial
setting
Change in
value per step
LSU OUT Paper feed from cassette -7.0 to 10.0 -2.4 0.1 mm
LSU BYP Paper feed from MP tray -7.0 to 10.0 0.0 0.1 mm
LSU T1 Paper feed from optional first paper
feeder (standard for 22ppm model)
-7.0 to 10.0 0.0 0.1 mm
LSU T2 Paper feed from optional second paper
feeder
-7.0 to 10.0 0.0 0.1 mm
LSU T3 Paper feed from optional third paper
feeder
-7.0 to 10.0 0.0 0.1 mm
LSU DUP Duplex mode (second side) -7.0 to 10.0 0.0 0.1 mm
Center line of printing (± 1.0 mm)
Correct image Output
example 1
Output
example 2
U034
U067
(P.1-3-20)
U072
(P.1-3-25)