2KJ/2KH
1-5-56
6. Replace the heat roller and refit all the
removed parts.
Caution
When replacing the heat roller, make sure
that the surface of the fuser thermistor is
cleaned with alcohol and is not deformed.
Also make sure that no foreign matter
adheres to the fuser thermostats.
Refit the heat roller gear while pushing the
idle gear in the direction indicated with the
arrow. Also make sure that the gears are
properly engaged.
After refitting the heat roller, push the roller
lightly to check that the detection surface of
the fuser thermistor comes in contact with
the roller.
Figure 1-5-94
Fuser thermistor
Fuser thermostat
Fuser thermostat
Right fuser unit
Idle gear
Heat roller gear
To Next Page
Loading...
