Kyocera TASKalfa 181 - Page 260

2KJ/2KH
2-3-20
YC5 1SGND -- Ground
Connected
to the cas-
sette paper
switch
2 PE I 0/5 V DC CPSW: On/Off
3 5V O 5 V DC 5 V DC power output to CPSW
4 NC - - Not used
YC6 1SGND -- Ground
Connected
to the cas-
sette feed
switch
2 FEED I 0/5 V DC CFSW: On/Off
3 5V O 5 V DC 5 V DC power output to CFSW
YC8 1 24V O 24 V DC 24 V DC power output to CPFCL
Connected
to the cas-
sette paper
feed clutch
2 CLT_RE O 0/24 V DC CPFCL: On/Off
YC9 1 24V O 24 V DC 24 V DC power output to CDM
Connected
to the cas-
sette drive
motor
2 MOTA O 0/24 V DC (pulse) CDM drive control signal
3 MOTB O 0/24 V DC (pulse) CDM drive control signal
4 MOTA- O 0/24 V DC (pulse) CDM drive control signal
5 MOTB- O 0/24 V DC (pulse) CDM drive control signal
Connector Pin No. Signal I/O Voltage Description