Need help?Do you have a question about the LaserLine Flatwork Ironer Series and is the answer not in the manual?
Provides warranty information for the unit.
Outlines the content and purpose of the manual.
Details safety precautions and guidelines for operation and maintenance.
Specifies necessary clearances and utility connections for installation.
Details steps for inspecting, uncrating, connecting utilities, and final checks.
Lists procedures to verify proper setup before initial operation.
Details maintenance required during the first month of operation.
Lists and describes built-in safety features of the unit.
Details the location and function of all operating controls.
Outlines daily routines for starting, waxing, handling, and shutting down the unit.
Covers factors affecting flatwork finish like conditioning, unit settings, and standards.
Lists daily preventive maintenance tasks to be performed.
Lists weekly preventive maintenance tasks for regular upkeep.
Lists monthly preventive maintenance tasks for thorough servicing.
Lists semi-annual preventive maintenance tasks for long-term care.
Reviews incoming power, distribution, controls, sensors, and safety switches.
Details drive mechanisms powering rotating parts and enabling flatwork finishing.
Explains exhaust blower and sail switch function for ventilation.
Covers gas requirements, heating, and control systems for safe operation.
Provides a step-by-step guide to the unit's operational stages.
Addresses issues related to the unit's initial startup sequence.
Troubleshoots problems related to adjusting and maintaining operating speed.
Addresses common issues affecting the final finish of the flatwork.
Troubleshoots problems related to the unit's mechanical components.
Solves issues related to the exhaust blower and ventilation.
Troubleshoots problems with the gas burner and heating system.
Critical safety steps and precautions before performing repair work.
Information on how to order replacement parts.
Procedures for maintenance and repair of the feed section.
Procedures for maintenance and repair of the return section.
Maintenance and repair procedures for the delivery section.
Procedures for maintaining and adjusting the compression roll.
Procedures for maintaining and replacing the drive chain.
Adjusting and replacing the machine speed sensor.
Procedures for cleaning and maintaining the ironing cylinder.
Procedures for inspecting, adjusting, and repairing the burner system.
To Next Page
General