GL16 Introduction
1-1
Chapter 1
INTRODUCTION
This chapter contains the following sections:
1.1 Warranty
1.2 Scope of Manual
1.3 Safety
The GL16 Gas-Heated Flatwork Ironer (Figure 1-1) is a one-piece unit that dries and irons sheets,
pillowcases, table linen, and other types of flatwork. The unit will process polyester/cotton blends, VISA
®
,
or all-cotton fabrics. This unit is available with ironing cylinder lengths from 60" to 135"
(1,525 mm to 3,430 mm). Type F units discharge flatwork to a front receiving shelf. Type R models can
be switched to discharge flatwork to either the front or rear receiving shelf.
Like the rest of the CHICAGO
product line, the GL16 is designed, manufactured, and assembled in
Chicago, Illinois. Before the CHICAGO
nameplate is affixed to any unit, a final inspection is performed,
including thorough testing under load conditions.
Any questions concerning the installation, operation, or repair of the unit should be directed to a local
authorized CHICAGO
®
dealer or the factory Service Department at:
! Chicago Dryer Company
2200 North Pulaski
Chicago, Illinois 60639
" (773) 235-4430
Fax (773) 235-4439
Email service@chidry.com
1.1 Warranty
A full page warranty statement is located at the front of this Instruction Manual. Please take the
time to review this warranty and understand its provisions.
Figure 1-1: The GL16 provides high quality flatwork finishing.
To Next Page
Loading...
General