Repair GL16
7-2
• Only work on the unit when it has been
completely cooled down, following the
procedures in the OPERATING
GUIDELINES chapter.
• Make sure the GAS ON/OFF switch is
turned to OFF and the TEMPERATURE
CONTROL is set to zero.
• All maintenance procedures should be
handled by at least two qualified persons.
Using the “buddy system” decreases the
risk of an accident.
• The work site should have lockout/tagout
procedures in place to comply with
government standards for performing
maintenance and repair. Ask a supervisor
for specific information.
• The JOG switch remains powered even
when one of the safety interlock switches
is open. This keeps power available for
emergency use. It is very important the
unit is properly tagged according
government-approved procedures
whenever repair work is being done.
WARNING
Know the proper lockout/
tagout procedures for
equipment during repair
work. Follow the rules
of your work site. Failure
to do so could result in
serious injury.
WARNING
Do not repair or correct any
condition without reading
and understanding this
REPAIR chapter. Only
qualified personnel should
troubleshoot and repair this
unit. Always ensure that the
machine is completely
cooled down and that power
is disconnected at the main
disconnect switch before
servicing the unit.
7.2 Parts Availability
Replacement and repair parts can be ordered
through your local authorized CHICAGO
®
distributor. Questions regarding the operation,
maintenance, troubleshooting, or repair of the unit
can also be directed to your distributor.
In addition, questions may be directed to the
Chicago Dryer Company factory Service
Department by calling (773) 235-4430.
NOTE: Use only factory-
approved and tested replacement
parts when repairing a
CHICAGO
®
machine. They are
specifically designed for each
model and serial number
machine. Overnight shipment of
parts is available.
To Next Page
Loading...