X-Stream Operator’s Manual
WM-OM-E Rev I 139
• Do not make any changes to the Windows folder.
• Do not make any changes to the BIOS settings.
• Do not make any changes to the Windows power management system.
System Restore
Although the scope creates regularly scheduled restore points automatically, before you install any
hardware or software on your instrument, LeCroy strongly recommends that you manually create a
restore point. The restore point resides on the scopes hard drive, so no external storage medium
(floppy disk, USB memory stick, etc.) is required.
To Create a Restore Point
1. From the File menu, minimize or Window the scope display to reveal the task bar.
2. In the task bar, select Start, Programs, Accessories, System Tools, System Restore.
3. Touch the Create a restore point radio button, then touch Next.
4. In the Restore point description box, indicate what software or hardware is going to be
added after the restore point is created, then touch Next.
5. The restore point will be created and a confirmation message will be displayed.
To Next Page
Loading...
Need help?
General
