46 WM-OM-E Rev I
WARNING
The WARNING sign indicates a potential hazard. It calls attention to a procedure,
practice or condition which, if not followed, could possibly cause bodily injury or death.
If a WARNING is indicated, do not proceed until its conditions are fully understood and
met.
CAT I
Installation (Overvoltage) Category rating per EN 61010-1 safety standard and is
applicable for the oscilloscope front panel measuring terminals. CAT I rated terminals
must only be connected to source circuits in which measures are taken to limit
transient voltages to an appropriately low level.
Operating Environment
The instrument is intended for indoor use and should be
operated in a clean, dry environment. Before using this
product, ensure that its operating environment will be
maintained within these parameters:
Temperature: 5 to 40
°
C
Humidity: Maximum relative humidity 80% for
temperatures up to 31
°
C decreasing linearly to 50%
relative humidity at 40
°
C.
Altitude: Up to 2,000 m
Note: Direct sunlight, radiators, and other heat sources should be taken
into account when assessing the ambient temperature.
WARNING
The scope must not be operated in
explosive, dusty, or wet
atmospheres.
CAUTION
Protect the scope’s display touch
screen from excessive impacts with
foreign objects.
CAUTION
Do not exceed the maximum
specified front panel terminal (CH1,
CH1, CH2, CH3, CH4, AUX IN) voltage
levels. Refer to Specifications for
more details.