• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration
information.
• Before you remove or make changes to drives, drive controllers (including controllers that are integrated
on the system board assembly), drive backplanes or drive cables, back up all important data that is stored
on drives.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
BashWCNZQEDP7o3EohXPEV
.
Procedure
Step 1. Make preparation for the task.
a. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the
top cover, or remove the server from the rack. See
“Remove the server from rack” on page 43.
b. Remove the top cover. See
“Remove the top cover” on page 148.
c. Disconnect the cable of the RAID flash power module.
Step 2. Remove the RAID flash power module from the air baffle.
Figure 85. Removing the RAID flash power module from the air baffle
a. Open the retention clip on the holder of the RAID flash power module.
b.
Take the RAID flash power module out of the holder.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install a RAID flash power module on the air baffle
Follow instructions in this section to install a RAID flash power module (also called supercap) on the air baffle.
About this task
118 ThinkSystem SR655 V3 User Guide
To Next Page
Loading...
