Figure 84. Installing the cable retainer
Step 5. Connect the cables to the system board assembly. See Chapter 6 “Internal cable routing” on page
153
.
After you finish
1. Install the air baffle. See
“Install the air baffle” on page 52.
2. Install the security bezel if you have removed it. See
“Install the security bezel” on page 125.
3. Complete the parts replacement. See
“Complete the parts replacement” on page 151.
RAID flash power module replacement
The RAID flash power module protects the cache memory on the installed RAID adapter. Follow instructions
in this section to remove and install a RAID flash power module (also called supercap).
•
“Remove a RAID flash power module from the air baffle” on page 117
• “Install a RAID flash power module on the air baffle” on page 118
Remove a RAID flash power module from the air baffle
Follow instructions in this section to remove a RAID flash power module (also called supercap) from the air
baffle.
About this task
Attention:
• Read
“Installation Guidelines” on page 35 and “Safety inspection checklist” on page 36 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 42.
Chapter 5. Hardware replacement procedures 117
To Next Page
Loading...
