Step 3. Remove the front I/O module from the front chassis.
Figure 39. Removing the front I/O module
a. Remove the screw that secure the front I/O module.
b.
Slide the media bay out of the front chassis.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the front I/O module
Follow instructions in this section to install the front I/O module.
About this task
Attention:
• Read “Installation Guidelines” on page 35 and “Safety inspection checklist” on page 36 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 42.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
BashWCNZQEDP7o3EohXPEV
.
Procedure
Chapter 5. Hardware replacement procedures 71
To Next Page
Loading...
