One 8 x SAS/SATA and one 8 x AnyBay backplanes
This section provides cable routing information for the server model with one 8 x SAS/SATA and one 8 x
AnyBay backplanes.
To connect power cables for the front backplane(s), refer to “Backplanes: server models with 2.5-inch front
drive bays” on page 163
.
To connect signal cables for the backplane(s), refer to the following cable routing scenarios depending on
your server configuration.
• “Onboard connectors” on page 179
• “Onboard connectors + 16i RAID/HBA adapter” on page 181
Onboard connectors
The following shows the cable connections for the 8 SAS/SATA + 8 AnyBay configuration with onboard
connectors.
Connections between connectors:
1 ↔ 1 , 2 ↔ 2 , 3 ↔ 3 , ... n ↔ n
Chapter 6
. Internal cable routing 179
To Next Page
Loading...
