Figure 52. Removing the memory module
a. Gently open the retaining clip on each end of the memory module slot.
b.
Grasp the memory module at both ends and carefully lift it out of the slot.
After you finish
1. A memory module slot must be installed with a memory module or a memory module filler. See
“Install a
memory module” on page 83
.
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install a memory module
Follow instructions in this section to install a memory module.
About this task
Attention:
• Read
“Installation Guidelines” on page 35 and “Safety inspection checklist” on page 36 to ensure that you
work safely.
• Memory modules are sensitive to static discharge and require special handling. Refer to the standard
guidelines at
“Handling static-sensitive devices” on page 38:
– Always wear an electrostatic-discharge strap when removing or installing memory modules.
Electrostatic-discharge gloves can also be used.
– Never hold two or more memory modules together so that they do not touch each other. Do not stack
memory modules directly on top of each other during storage.
– Never touch the gold memory module connector contacts or allow these contacts to touch the outside
of the memory module connector housing.
Chapter 5. Hardware replacement procedures 83
To Next Page
Loading...
Need help?
General
