Figure 53. Installing the memory module
a.
Gently open the retaining clip on each end of the memory module slot.
b.
Align the memory module with the slot, and gently place the memory module on the slot
with both hands.
c.
Firmly press both ends of the memory module straight down into the slot until the retaining
clips snap into the locked position.
After you finish
Complete the parts replacement. See
“Complete the parts replacement” on page 151.
OCP module replacement
Follow instructions in this section to remove and install the OCP module.
• “Remove the OCP module” on page 85
• “Install the OCP module” on page 87
Remove the OCP module
Follow instructions in this section to remove the OCP module.
About this task
CAUTION:
Power off the server and disconnect all power cords from their power sources before performing this
procedure.
Attention:
Chapter 5. Hardware replacement procedures 85
To Next Page
Loading...
