Figure 41. 2.5-inch hot-swap drive
Figure 42. 3.5-inch hot-swap drive
Step 3. Grasp the handle and slide the drive out of the drive bay.
Figure 43. 2.5-inch hot-swap drive
Figure 44. 3.5-inch hot-swap drive
After you finish
1. Install a new drive or drive filler to cover the drive bay. See
“Install a hot-swap drive” on page 74.
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install a hot-swap drive
Follow instructions in this section to install a hot-swap drive.
About this task
Attention:
• Read
“Installation Guidelines” on page 35 and “Safety inspection checklist” on page 36 to ensure that you
work safely.
• To avoid damage to the drive connectors, make sure that the server top cover is in place and fully closed
whenever you install or remove a drive.
74
ThinkSystem SR655 V3 User Guide
To Next Page
Loading...
