After you finish
1. Install a new OCP module or a card filler.
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install the OCP module
Follow instructions in this section to install the OCP module.
About this task
CAUTION:
Power off the server and disconnect all power cords from their power sources before performing this
procedure.
Attention:
• Read
“Installation Guidelines” on page 35 and “Safety inspection checklist” on page 36 to ensure that you
work safely.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Note: If there is an OCP module installed, when the system is powered off but still plugged in to AC power,
fans 1 and 2 may continue to spin at a much lower speed. This is the system design to provide proper
cooling for the OCP module.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
BashWCNZQEDP7o3EohXPEV
.
Procedure
Step 1. Touch the static-protective package that contains the new part to any unpainted surface on the
outside of the server. Then, take the new part out of the package and place it on a static-protective
surface.
Step 2. Remove the OCP module filler if there is.
Step 3. Install the OCP module.
Note: Ensure that the module is fully seated and the thumbscrew is securely tightened. Otherwise,
the OCP module will not get full connection and may not function.
Chapter 5. Hardware replacement procedures 87
To Next Page
Loading...
