Lenovo ThinkSystem SR655 V3 - Remove the server from rack

• Press the power button to start an orderly shutdown (if supported by your operating system).
• Press and hold the power button for more than 4 seconds to force a shutdown.
When in a standby state, the server can respond to remote power-on requests sent to the Lenovo XClarity
Controller. For information about powering on the server, see
“Power on the server” on page 42.
Server replacement
Follow instructions in this section to remove and install the server.
•
“Remove the server from rack” on page 43
• “Install the server to rack” on page 46
Remove the server from rack
Follow instructions in this section to remove the server from the rack.
S036
18 - 32 kg (39 - 70 lb) 32 - 55 kg (70 - 121 lb)
CAUTION:
Use safe practices when lifting.
R006
CAUTION:
Do not place any object on top of a rack-mounted device unless that rack-mounted device is intended
for use as a shelf.
About this task
Attention:
• Read
“Installation Guidelines” on page 35 and “Safety inspection checklist” on page 36 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 42.
CAUTION:
Make sure to have three people operate the server removal procedures to prevent injury.
Watch the procedure
Chapter 5. Hardware replacement procedures 43