• Read “Installation Guidelines” on page 35 and “Safety inspection checklist” on page 36 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 42.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Note: If replacing with a new MicroSD card, the firmware historical data and user data stored in the
defective MicroSD card will be lost. After a new MicroSD card is installed, subsequent firmware update
history will be saved to the new card.
Figure 51. Installing the MicroSD card
Step 1.
Place the MicroSD card into the socket.
Step 2.
Close the socket lid.
Step 3.
Slide the socket lid to the lock position.
After you finish
If you are instructed to return the old RAID flash power module, follow all packaging instructions and use any
packaging materials that are provided.
Memory module replacement
Use the following procedures to remove and install a memory module.
Chapter 5. Hardware replacement procedures 81
To Next Page
Loading...
Need help?
General
