Figure 47. Rotating the fan cage
Step 3. Remove the intrusion switch assembly from the fan cage.
Note: The blowup in the illustration shows the fan cage upside down.
Figure 48. Removing the intrusion switch
a. Move the intrusion switch connector in the shown direction to disengage it from the
keyhole.
b.
Release the intrusion switch cable from the pre-cut slots on the foam and fan cage bottom.
c.
Release the intrusion switch cable from the cable clip.
d.
Slide and pull the intrusion switch to remove it from the holder.
After you finish
1. Install a new intrusion switch. See
“Install the intrusion switch” on page 78.
Chapter 5. Hardware replacement procedures 77
To Next Page
Loading...
