Lenze EVS 9300 series - Page 113

Contents
iii
L
EDSVS9332S-D11 EN 3.0
9.2.37 Flipflop element (FLIP) 9-131..................................................
9.2.38 Gearbox compensation (GEARCOMP) 9-134.......................................
9.2.39 Limiter (LIM) 9-135.........................................................
9.2.40 Internal motor control (MCTRL) 9-136............................................
9.2.41 Mains failure control (MFAIL) 9-145.............................................
9.2.42 Motor phase failure detection (MLP) 9-156........................................
9.2.43 Monitor outputs of monitoring system (MONIT) 9-157................................
9.2.44 Motor potentiometer (MPOT) 9-158.............................................
9.2.45 Logic NOT 9-161...........................................................
9.2.46 Speed setpoint conditioning (NSET) 9-163.........................................
9.2.47 OR operation (OR) 9-168.....................................................
9.2.48 Oscilloscope function (OSC) 9-171..............................................
9.2.49 Process controller (PCTRL1) 9-175..............................................
9.2.50 Phase addition block (PHADD) 9-178............................................
9.2.51 Phase comparator (PHCMP) 9-179..............................................
9.2.52 Actual phase integrator (PHDIFF) 9-181..........................................
9.2.53 Signal adaptation for phase signals (PHDIV) 9-182...................................
9.2.54 Phase integrator (PHINT) 9-183................................................
9.2.55 First order delay element (PT1) 9-189............................................
9.2.56 CW/CCW-QSP link (R/L/Q) 9-190...............................................
9.2.57 Homing function (REF) 9-191..................................................
9.2.58 Ramp function generator (RFG) 9-197............................................
9.2.59 Sample and hold function (S&H) 9-199...........................................
9.2.60 S-shape ramp function generator (SRFG) 9-200....................................
9.2.61 Output of digital status signals (STAT) 9-202.......................................
9.2.62 Control of a drive network (STATE-BUS) 9-203.....................................
9.2.63 Storage block (STORE) 9-204..................................................
9.2.64 Multi-axis synchronisation (SYNC1) 9-208.........................................
9.2.65 Edge evaluation (TRANS) 9-216................................................
9.3 Monitoring 9-219...................................................................
9.3.1 Reactions 9-219...........................................................
9.3.2 Set reactions 9-226.........................................................
9.3.3 Monitoring functions 9-227...................................................
9.3.4 Fault indication via digital output 9-254..........................................