Function library
Code table
9-266
l
EDSVS9332S-D12 EN 3.0
Code ImportantPossible settings
No. SelectionLenzeLCD
C0360
0 65535 CAN
Telegram counter (number of telegrams)
Count values > 65535: Restart with 0
1 MESSAGE OUT all sent
2 MESSAGE IN all received
3 MESSAGE OUT1 sent to CAN-OUT1
4 MESSAGE OUT2 sent to CAN-OUT2
5 MESSAGE OUT3 sent to CAN-OUT3
6 MESSAGE POUT1 sent to parameter channel 1
7 MESSAGE POUT2 sent to parameter channel 2
8 MESSAGE IN1 received from CAN-IN1
9 MESSAGE IN2 received from CAN-IN2
10 MESSAGE IN3 received from CAN-IN3
11 MESSAGE PIN1 received from parameter channel 1
12 MESSAGE PIN2 received from parameter channel 2
C0361
0 {1 %} 100 CAN
Bus load
To ensure a perfect operation, the total bus load
(all connected devices) should be less than 80%
1 LOAD OUT all sent
2 LOAD IN all received
3 LOAD OUT1 sent to CAN-OUT1
4 LOAD OUT2 sent to CAN-OUT2
5 LOAD OUT3 sent to CAN-OUT3
6 LOAD POUT1 sent to parameter channel 1
7 LOAD POUT2 sent to parameter channel 2
8 LOAD IN1 received from CAN-IN1
9 LOAD IN2 received from CAN-IN2
10 LOAD IN3 received from CAN-IN3
11 LOAD PIN1 received from parameter channel 1
12 LOAD PIN2 received from parameter channel 2
C0362 SYNC CYCLE 0 {0.1 ms} 32.0 CAN
Time between two sync telegrams on the
system bus
C0363 SYNC CORR 1 1
2
3
4
5
0.8 μs
1.6 μs
2.4 μs
3.2 μs
4.0 μs
CAN
Correction value for C0362
[C0364] CAN ACTIVE 1000 FIXED0 → Selection list 2 Pre-operat. after operat.
Activate process data externally
Change over from pre-operation to operation
C0365 (C0364) Input signal CAN active
C0366 SYNC RESPONSE 1 0
1
no sync response
sync response
CAN Sync Response
C0367 SYNC RX ID 128 1 {1} 256 CAN Sync Rx Identifier
C0368 SYNC TX ID 128 1 {1} 256 CAN Sync Tx Identifier
C0369 SYNC TX TIME 0 0 {1} 65000 CAN Sync Tx Time
C0400 OUT -199.99 {0.01 %} 199.99 AIN1
Output signal display
[C0402] OFFSET 19502 FCODE-26/1 →Selection list 1 AIN1
Configuring offset of AIN1
[C0403] GAIN
19504
FCODE-27/1 →Selection list 1 AIN1
Configuring gain of AIN1
To Next Page
Loading...