Function library
Code table
9-275
l
EDSVS9332S-D12 EN 3.0
Code ImportantPossible settings
No. SelectionLenzeLCD
C0611
-199.99 {0.01 %} 199.99
1 (C0610/1)
2 (C0610/2)
3 (C0610/3)
C0620 DB1 GAIN 1.00 -10.00 {0.01 } 10.00 DB1
Gain
C0621 DB1 VALUE 1.00 0.00 {0.01 %} 100.00 DB1
Dead band
[C0622] IN 1000 FIXED0% →Selection list 1 DB1
Configuration - analog input signal
C0623 (C0622) -199.99 {0.01 % } 199.99
C0630 MAX LIMIT 100.00 -199.99 {0.01 %} 199.99 LIM1
Setting the upper limitation
C0631 MIN LIMIT -100.0 -199.99 {0.01 %} 199.99 LIM1
Setting the lower limitation
[C0632] IN 1000 FIXED0% →Selection list 1 LIM1
Configuration - analog input signal
C0633 (C0632) -199.99 {0.01 % } 199.99
C0640 DELAY T 20.00 0.01 {0.01 s} 50.00 PT1 -1
Setting the time constant
[C0641] IN 1000 FIXED0% Æ Selection list 1 PT1-1
Configuration - analog input signal
C0642 (C0641) -199.99 {0.01 % } 199.99
C0650 DT1-1 GAIN 1.00 -320.00 {0.01 } 320.00 DT1-1
Gain
C0651 DELAY T 1.00 0.005 {0.01 s} 5.000 DT1-1
Time constant
[C0652] IN 1000 FIXED0% →Selection list 1 DT1-1
Configuration - analog input signal
C0653 SENSIBILITY 1 1
2
3
4
5
6
7
15-bit
14-bit
13-bit
12-bit
11-bit
10-bit
9-bit
DT1-1
Input sensitivity
C0654 (C0652) -199.99 {0.01 % } 199.99
C0655 NUMERATOR 1 -32767 {1} 32767 CONV5
Numerator
C0656 DENOMINATOR 1 1 {1} 32767 CONV5
Denominator
[C0657] IN 1000 FIXED0% →Selection list 1 CONV5
Configuration - analog input signal
C0658 (C0657) -199.99 {0.01 % } 199.99
[C0661] IN 1000 FIXED0% →Selection list 1 ABS1
Configuration - analog input signal
C0662 (C0661) -199.99 {0.01 % } 199.99
C0671 RFG1 TIR 0.000 0.000 {0.01 s} 999.900 RFG1
Setting the acceleration time T
ir
C0672 RFG1 TIF 0.000 0.000 {0.01 s} 999.900 RFG1
Setting the deceleration time T
if
[C0673] IN 1000 FIXED0% →Selection list 1 RFG1
Configuration - analog input signal
[C0674] SET 1000 FIXED0% →Selection list 1 RFG1
Configuration - analog input signal
[C0675] LOAD 1000 FIXED0 → Selection list 2 RFG1
Configuration - digital input signal
To Next Page
Loading...