Function library
Code table
9-291
l
EDSVS9332S-D12 EN 3.0
Code ImportantPossible settings
No. SelectionLenzeLCD
[C1102] → Selection list 2
FCNT1
1 CLKUP 1000 FIXED0
Configuration - digital input signals
2 CLKDWN 1000 FIXED0
3 LOAD 1000 FIXED0
C1103
-32768 {1} 32768
1 (C1101/1)
2 (C1101/2)
C1104
1 (C1102/1)
2 (C1102/2)
3 (C1102/3)
C1120 SYNC MODE 2 0
1
2
Sync switched off
CAN Sync activated
Terminal Sync activated
SYNC1
Function selection
[C1121] 0 {1 ms} 13 SYNC1
1 SYNC CYCLE 2 Definition for the cycle time of sync signals
(slave);
• for system bus only
2 INTERPOL. CYCL 2 Definition of the interpolation time between the
sync signals (in the slave)
• only for terminal
• the interpolation is restarted with every sync
signal
C1122 SYNC TIME 0.460 0.000 {0.001 ms} 10.000 SYNC1
Phase shift between CAN Sync and internal
control program cycle
• for system bus only
• depending on the baud rate and bus load
C1123 -0.450 {0.001 ms} 0.450 SYNC1
1 PHASE SHIFT 0.000 Phase shift between Terminal Sync and internal
control program cycle
• for Terminal Sync only
2 SYNC WINDOW 0.000 Synchronisation window for synchronisation
edge of the Terminal Sync (LOW-HIGH edge)
• for Terminal Sync only
• if the sent sync signal is in the window,
SYNCx-STAT = HIGH
[C1124] IN1 1000 FIXED0% →Selection list 1 SYNC1
Configuration - analog input signal
[C1125] IN2 1000 FIXED0INC → Selection list 3 SYNC1
Input signal configuration
[C1126] IN3 1000 FIXED0% →Selection list 1 SYNC1
Configuration - analog input signal
C1127 (C1124) -2147483648 {1} 2147483647
C1128 (C1125) -2147483648 {1 inc} 2147483647
C1129 (C1126) -2147483648 {1 inc} 2147483647
C1140 FUNCTION 0 0
1
2
Rising edge
Falling edge
Both edges
TRANS3
Selection of the edge evaluation
C1141 PULSE T 0.001 0.001 {0.001 s} 60.000 TRANS3
Setting of the pulse period
[C1143] IN 1000 FIXED0 → Selection list 2 TRANS3
Configuration - digital input signal
C1144 (C1143)
C1145 FUNCTION 0 0
1
2
Rising edge
Falling edge
Both edges
TRANS4
Selection of the edge evaluation
To Next Page
Loading...