Lenze EVS 9300 series - Page 499

Index
abc
14-7
L
EDSVS9332S EN 3.0
Internal motor control (MCTRL), 9-136
- Additional torque setpoint, 9-138
- Current controller, 9-138
- Phase controller, Influence of phase controller, 9-142
- Quick stop (QSP)
Field weakening, 9-144
Switching frequency changeover, 9-144
- Quick stop QSP, 9-143
- Speed controller, 9-140
- Speed setpoint limitation, 9-141
- Torque control, with speed limitation, 9-141
- Torque limitation, 9-139
Invert main setpoint, 8-5
Inverter (ANEG), 9-64
J
JOG setpoint, 8-4 , 9-257
JOG setpoints, 9-165
Jumper, analog setpoint selection, 4-45
K
Keypad
- Status indications, 6-1
- Status messages, 10-2
Keypad EMZ9371BC
- Change parameters, 7-5 , 7-6 , 7-9
- Changing parameters, 7-7 , 7-8
- Commissioning, 7-2
- Data, 7-12
- Diagnostics with, 7-10
- Display elements, 7-3
- Function keys, 7-4
- Parameter set loading, 7-6
- Parameter set transfer, 7-7
L
Labelling, Controller, 1-3
Layout of the safety instructions, 2-4
Leakage inductance, 9-258
LECOM, status word C0150, 10-2
Legal regulations, 1-3
Liability, 1-3
Limiter (LIM), 9-135
Logic NOT, 9-161
Low voltage LU, 9-230
M
Main setpoint, 8-4
Main setpoint path, 9-164
Mains conditions, 4-22
Mains connection, 4-24
- Protection, 4-26
Mains failure control (MFAIL), 9-145
- Fast mains recovery (KU), 9-154
- Mains failure detection, 9-146 , 9-148
- Restart protection, 9-154
Mains failure detection, 9-146 , 9-148
Mains filters, 3-8
Mains types, 4-22
Manufacturer, 1-3
Master configuration, 8-12
- CINH at the master, 8-15
- features, 8-12
- following error limit, 8-12
- homing function, 8-12
- master frequency output X10, 8-13
- Master integrator, 8-13
- phase adjustment, 8-15
- Phase offset, 8-15
- phase trimming, 8-14
- phase trimming, speed correction, 8-12
- QSP at the master, 8-15
- QSP at the slave 0, 8-15
- Setpoint conditioning, 8-14
- speed trimming, 8-14
Master current, 8-4
Master frequency bus, 8-16
- cascading factor, 8-18
Master frequency cascade, 8-19
- cascading factor, 8-21
- CINH at the slave, 8-21
- QSP at the slave, 8-21
Master frequency coupling, 8-11
- gearbox factors, 8-11
- master configuration, 8-12
- System description, 8-11
Master frequency input (DFIN), 9-97
Master frequency input (X9), 4-52
Master frequency output (X10), 4-52
Master frequency output X10, 8-13
- encoder constant, 8-13
Master integrator, 8-11 , 8-13