Lenze EVS 9300 series - Page 502

Index
abc
14-10
L
EDSVS9332S EN 3.0
S
S r amp, PT1 element, 9-167
S-shape ramp function generator (SRFG), 9-200
S-shaped acceleration characteristic, 8-5
Safety information, Layout
- Other notes, 2-4
- Warning of damage to material, 2-4
- Warning of damage to persons, 2-4
Safety instructions, 2-1
Sample and hold function (S&H), 9-199
Screw-tightening torques, motor cable, 4-31
Selection lists, 9-296
- Signal links, 9-296
Selection of motor type, 9-258
Selection of the feedback system, 9-256
Servo inverter. Siehe Controller
Setpoint conditioning of the slave, 8-18
Setpoint inversion, Ramp function generator, main
setpoint, 9-166
Setting the integral component, 9-140
Shielding
- Control cable, 4-39
-EMC, 4-57
Short-circuit OC1, 9-232
Signal conversion (CONV), 9-82
Signal flow diagrams, 13-1
Signal links, Selection list, 9-296
sin(2) shape, 9-200
Sin/cos encoder, connection, 4-51
Slave, 8-16
Speed control, 8-4 , 12-2 , 12-5 , 12-7 , 12-10
,12-12
- Acceleration and deceleration times, 8-5
- Additional acceleration and deceleration times, 8-5
- Additional setpoint, 8-5
- Additional torque setpoint, 8-7
- Controller inhibit, 8-7
- Fault reset, 8-8
- Input of the direction of rotation, 8-6
- Invert main setpoint, 8-5
-JOGsetpoint, 8-4
- Main setpoint, 8-4
- Master current, 8-4
- S-shaped acceleration characteristic, 8-5
- Setpoint input, 8-4
- Speed limit, 8-7
Speed controller, 9-140
- Setting the integral component, 9-140
Speed conversion (CONVPP), 9-87
Speed limit, 8-7
Speed limitation, 8-10
Speed ratio synchronism, 8-23
Speed setpoint conditioning (NSET), 9-163
- Additional setpoint, 9-167
- JOG setpoints, 9-165
- Main setpoint, 9-164
- S ramp, PT1 element, 9-167
- Setpoint inversion, Ramp function generator, main setpoint,
9-166
Speed setpoint limitation, 9-141
Speed synchronism, 8-23
Speed travel profile, 8-31
Speed trimming, 8-14
Speed-ratio synchronism, 8-11
Speed-synchronous operation, 8-11 , 8 -16
Speed-synchronous running, 8-23
State bus connection, 9-203
STATE-BUS, 4-46
Status, 6-1
Status messages, 10-2
- In Global Drive Control, 6-2
- On the controller, 6-1
- On the keypad, 6-1
Statusword,9-260,10-2
Storage block (STORE), 9-204
Switching frequency changeover, 9-144